
Great running Tsugami BS19 paired with an IEMCA Elite 220. This machine is ready to hit your production floor running. The machine will come with high pressure pumps and a chip conveyor.
Tsugami BS18(b)-III
yr: 2001
IEMCA Elite 220
Yr: 2011
Listing Directory: M & E
Great running Tsugami BS19 paired with an IEMCA Elite 220. This machine is ready to hit your production floor running. The machine will come with high pressure pumps and a chip conveyor.
Tsugami BS18(b)-III
yr: 2001
IEMCA Elite 220
Yr: 2011
Great working compressor with dryer. Bought new in 2018 and used temporarily for support equipment.
Spindle hole diameter: 26 mm
Control: Siemens Simatic OP 27
Bar Size Diameter:
-Round: 26mm
-Square: 19mm
-Hexagonal: 22mm
-Octagonal: 24mm
Normal/Special Feed of the Bar up to: 125mm / 290mm
-Normal (Total/Working Travel): 80mm / 64mm
-Special (Total/Working Travel): 115mm / 90mm
Travel of Cross Slides (Total Travel / Working Travel)
-Upper Slide: 32/23mm
-Central Upper Slide: 32/20mm
-Central Lower Slide: 40/22mm
-Lower Slide: 50/30mm
Number of Spindle Speeds: 49
Spindle Speeds
-Range One: 600 – 5,000 RPM
Driving Motor Power: 29 HP
LNS Tryton SST4.R 9mm ID Reel Barfeeder
Item in good working condition when removed from service, was paired with a Tornos Deco 10. Buyer must arrange freight pickup.
Serial # 6276
Yr: 1995
LNS Hydrobar 6.35HS-4.8 barfeeder
Item in working condition when removed from service, was paired with a Tornos Deco 13.
Serial #41495
Yr: 2000
Good condition bars stored on material rack. Surplus due to lost business. Make an offer! Thank you
Good condition material in original packaging. No longer have the business that it was purchased for and willing to make a deal.
+/- .002 tolerance and both ends chamfered. Cold finished.
Make an offer!
Thank you.
Cleaned, gone through and in very good condition
$250 or best offer
Serial #: 642-12-2-4-81 (Machine serial #: 542-2-7747 & 542-3-320 & up per book, but am told will also work on older Ultramatics 542-2-5601 thru 542-2-7747 & 542-3-51 thru 542-3-320)
Arbor TIR within .0002″
Arbor end play – none detected
Bronze gear in very good condition, minimal backlash
Includes blade as shown 2-1/4″ x .064 HSS LDE, needs sharpening
Includes spacers on arbor as shown
Machined surfaces are clean and in good condition
Dual voltage motor as shown
Believe this will also fit an Ultramatic #3
Unit is heavy and may be shipped in 2 boxes
On ebay also: https://www.ebay.com/itm/185740262207
I have 1,000 lbs of CDA340 H02 Round Brass. Drawn to Ø.1563 and 144″ long. Material certs available upon request. Material does meet ASTM-B-453 and is DFARS compliant.